Today's Special!
phone: (630) 621 4198

  Types of Adhesives 

All Adhesives
Silicone Adhesives
Thermal Management
   »  Thermally Conductive Silicones

   »  Thermally Conductive Epoxies

   »  Very High Thermal Conductivity

Film Lamination
Epoxy Adhesives
Coating & Potting
Sealing Solutions
Electrical Conducting
Optical Applications
Media Protection
Adhesion & Bonding
Die Attachment
Snap / Fast Cure

Adhesive Details


Select package type
50 mL Cartridge, Price: $66.00
200 mL Jar, Price: $258.00
Input your order qty

USG390 is a high thermally conductive adhesive. It is a non-slump, addition-curing, ready-to-use, two-component silicone that cures at room temperature or elevated temperature to a rubber with excellent thermal conductivity. With heat cure, the adhesive provides strong bonding strength to various substrates. The cured material provides stress compliance for thermal cycles. USG390 is both dispensable and printable.

Special Features and Benefits
• High thermal conductivity
• Almost constant properties from –50 to 180 °C
• Low modulus for stress compliance
• Low bleeding, low volatile
• Strong adhesion to many substrates without using primer if cures at elevated temperature

Typical Applications
• Bonding of electronic parts to dissipate heat
• Automotive electronics
• Semiconductor and Telecommunications
• Between high heat power device and heat sink
• Thermally conductive vibration dampening
• Couple thermal stress while dissipating heat

USG390 has a shelf life of at least 6 months when stored in cold (below < 21°C) in the originally sealed container.

Click here to view the Technical Datasheet (TDS) of this product in details (PDF File) »

Processing Instruction

Important! USG390 is platinum cure system. Please keep applied surface clean and avoid using this material on any surface that contains sulfur, amine, phosphorous, organo-metals, acid, etc. because these containments could inhibit the cure of the material.
For the package in a container (not in a cartridge), to ensure homogeneity of the material, it is suggested that the component be stirred thoroughly before it is removed or processed in order to uniformly disperse any fillers that might have settled during storage.
We recommend running preliminary tests to optimize conditions for the particular application. Comprehensive processing instructions can be obtained by contacting directly to

USG390 has a shelf life of at least 6 months when stored below 21°C in the originally sealed container. The 'Best use before end' date of each batch appears on the product label. Storage beyond the date specified on the label does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Safety information
Addition curing USG390 silicone adhesive contains neither toxic nor corrosive substances that might require special handling precautions. General hygiene regulations should be observed. Comprehensive instructions are given in the corresponding Material Safety Data Sheets. They are available on request from

The figures listed in this datasheet are in good faith with the present state of our knowledge, but should not be used in substitution for user’s tests. We reserve the right to alter product constants within the scope of technical progress or new developments. The suggestions for use in this sheet should be checked by preliminary trials because the user’s processing conditions are out of our control. The suggestions for use should not be in substitution of user from the obligation of investigating the possibility of infringement of third parties’ patents or rights. This datasheet does not constitute a warranty, either express or implied, of the fitness or suitability of the products for a particular purpose. For technical, quality, or product safety questions, please contact directly to

Technical Support


  Shopping Cart is Empty

For bulk orders,
please call us at:
(630) 621 4198

Questions or comments?
Please send an email to: