Today's Special!
phone: (630) 621 4198

  Types of Adhesives 

All Adhesives
Silicone Adhesives
   »  Heat Cure

   »  Room Temp Cure (RTV)

   »  Silicone Sealant

   »  Electrical Conducting

   »  Thermal Conducting

   »  Optical Silicone

   »  Silicone Potting Gel

   »  Silicone Coating

   »  High Voltage Insulating

Thermal Management
Film Lamination
Epoxy Adhesives
Coating & Potting
Sealing Solutions
Electrical Conducting
Optical Applications
Media Protection
Adhesion & Bonding
Die Attachment
Snap / Fast Cure

Adhesive Details

** The actual package type may not be the same as shown in the photo **

Select package type
50 mL Cartridge, Price: $35.00
200 mL Cartridge, Price: $149.00
Input your order qty

USG711 is a room temperature cure silicone adhesives sealant. It is a one-component, non-slump silicone paste that cures when it is exposed to ambient moisture. After cure, it forms a soft rubber with strong tensile strength and long elongation. It bonds to most metals and plastics, such as aluminum, copper, PBT, ABS, Nylon, with excellent bonding strength. It can be automated to dispense from pail or extruded from cartridge.

Special Features and Benefits
• One part and non-slumping
• Strong bonding to various substrates
• Very flexible over -40°C to 180°C
• Extremely low thermal stress

Typical Applications
• Seal lids, covers, housings, connectors
• Form compression gaskets
• Water resistant sealing
• Automotive electronics
• Semiconductor and Telecommunications
• Vibration dampening
• Thermal stress coupling

Click here to view the Technical Datasheet (TDS) of this product in details (PDF File) »

Processing Instruction

Important! To reach good bonding, the surface to be bonded to needs to be clean and free of oil, grease, lubricants, soaps, dust, mold release agents, etc. USG711 is not recommended for use on polycarbonate or in direct contact with gasoline, diesel fuel or hot engine coolant.

We recommend running preliminary tests to optimize conditions for the particular application. The cure of USG711 may be accelerated with a higher humidity and temperature. Recommendations for automated dispensing equipment and accelerated cure profiles can be obtained by contacting directly to

USG711 has a shelf life of at least 12 months when stored at ambient (<25°C) in the originally sealed container. Storage beyond the date specified does not necessarily mean that the product is no longer usable. In this case however, the properties required for the intended use must be checked for quality assurance reasons.

Safety information
USG711 silicone releases low content of cyclohexylamine volatile by-product in cure process when it is exposed to moisture. Please use adequate ventilation in its cure stage. General hygiene regulations should be observed. Comprehensive instructions are given in the corresponding Material Safety Data Sheets which are available on request from

The data presented in this leaflet are in accordance with the present state of our knowledge, but do not absolve the user from carefully checking all supplies immediately on receipt. We reserve the right to alter product constants within the scope of technical progress or new developments. The recommendations made in this leaflet should be checked by preliminary trials because of conditions during processing over which we have no control, especially where other companies’ raw materials are also being used. The recommendations do not absolve the user from the obligation of investigating the possibility of infringement of third parties’ rights and, if necessary, clarifying the position. Recommendations for use do not constitute a warranty, either express or implied, of the fitness or suitability of the products for a particular purpose. For technical, quality, or product safety questions, please contact directly to

Technical Support


  Shopping Cart is Empty

For bulk orders,
please call us at:
(630) 621 4198

Questions or comments?
Please send an email to: